Foundation Programming Portal
Hatch FTX/FRX LED Driver Family Installation Instructions
This installation guide covers the following Hatch Transformers Foundation Series Class P programmable LED drivers:
Note: Table will horizontally scroll on smaller screen sizes.
Model Number | Output Voltage Range (V) | Programmed Output Current Range (V) |
|---|---|---|
FTX30-0700T-42-UNV | 20-42 | 350-700 |
FTX15-0350T-42-UNV | 20-42 | 150-350 |
FTX15-0500T-30-UNV | 15-30 | 200-500 |
FTY30-0700T-42-UNV | 20-42 | 350-700 |
FTY15-0350T-42-UNV | 20-42 | 150-350 |
FTY15-0500T-30-UNV | 15-30 | 200-500 |
FRX15-0350T-42-UNV | 20-42 | 150-350 |
FRX15-0500T-30-UNV | 15-30 | 200-500 |
Max/min output voltages are constant throughout the programmable range of the driver.
For dry and damp locations only.
Tc max 85C.
Output and wired control circuit are isolated Class 2 circuits. Do not connect non-isolated circuits to either circuit.
For Connections Use Wire Rated for at Least 90°C (194°F); POUR LES CONNEXIONS, UTILISER DES CONDUCTEURS D’ALIMENTATION CONVENANT 90°C
These LED drivers are dimmable using phase cut dimmers and/or a 0-10V wired control circuit.
For FTX and FRX models:
Use only within an enclosure; DOIT ÊTRE INSTALLÉ DANS UNE ENCEINTE
Wired Control Circuit Description
The dimming control lines DIM+/DIM- are isolated Class 2 control lines that are configured as a 120uA current source, typically 1-9V. Dim-to-off level and hysteresis are programmable. The output current dimming level of the Foundation series LED drivers is controlled by connecting a 0-10V dimmer or potentiometer between DIM+ and DIM-. Do not connect more than one dimmer type to control lines. Max leakage current of dimming leads is 0.01mA.
